in windows i'm not sure if you would see it in device manager. You need to find a way to check if it is connecting as a usb dfu device.
It should now be in the dfu mode waiting for upload The way it works is you need to set boot0, basically pressing that button that the vendor placed as boot0 on the board. Stm32 has a built-in dfu usb boot loader. Usb 7-4: Product: WeAct STM32 HID Bootloader
Usb 7-4: New USB device found, idVendor=0483, idProduct=572a Usb 7-4: Manufacturer: STMicroelectronics Usb 7-4: New USB device strings: Mfr=1, Product=2, SerialNumber=3 Usb 7-4: New USB device found, idVendor=0483, idProduct=df11 just in case I erase one (COUGH) and need to re-install it? Can all three co-exist? Or just the first two? If the STM32duino bootloader cannot coexist, which bootloader(s) does it replace? Where are each of these three stored in memory. * (Hardware) STM32 BOOTLOADER (pre-installed on stm32 chip) I'm a bit confused as to the differences in these STM32-F411 bootloaders (similar for F401).
